26.Route the end of the Short Cable (94) around the indicated 3 1/2" Pulley (55) in the "t"
Plates (75).
Insert a 3/8" x 2 3/4" Bolt (16) into one side of the Top Brace (86). Slide a 3/8" x 3/8" Metal
Spacer (6) onto the Bolt. Lay the Short Cable
(94)over a 3 1/2" Pulley (55). Slide the Pulley and another 3/8" x 3/8" Metal Spacer (6) onto the Bolt. Insert the Bolt through the other side
of the Top Brace and tighten a 3/8" Nylock Nut (15) onto the Bolt.
27.Press the Domed Inner Cap (34) into the lower end of the Weight Selector (82).
Slide a Weight (79) onto the upper end of the Weight Selector (82). Make sure that the
Weight is turned so the pin groove is down- ward.
Insert the end of the Short Cable (94) into the upper end of the Weight Selector (82) and attach it with the 5/16" x 1 1/2" Bolt (33) and a 5/16" Nylock Nut (4).
26
86
15
27
/
Pin Groove
28. Wrap | the | of the Long Cable | (93) | 28 | |||||
under | a 3 1/2" Pulley (55). Attach | the Pulley | |||||||
to the | Leg | Press | Frame | (72) | with | a | 3/8" x |
| |
3 1/2" | Bolt | (5), 3/8" Washer | (8) | and | 3/8" |
| |||
Nylock Nut | (15). | Make | sure | that |
| the | Cable | is | |
between the Pulley and | the | pin | on the Leg |
| |||||
Press | Frame. |
|
|
|
|
|
|
| |
11
