10.Attach a 3 1/2" "U" Bracket (98) to the left Arm (51) with a 5/16" x 2 1/2" Bolt (20), 3/8" Washer (8) and 5/16" Nylock Nut (4). Do not overtighten the Nylock
Attach a Thin "L" Bracket (99) to the 3 1/2" "U" Bracket (98) with a 5/16" x 2 1/4" Bolt
(14)and 5/16" Nylock Nut (4). Make sure that the Thin "L" Bracket is turned as shown. Do
not overtighten the Nylock
Attach a 3 1/2" "U" Bracket (98) and Thin "L" Bracket (99) to the right Butterfly Arm (51) in the same manner.
11.Press two 1 3/4" x 1 3/4" Inner Caps (28) into the Leg Press Frame (72).
Attach the Leg Press Frame (72) to the Base
(69)with a 3/8" x 2 3/4" Bolt (16) and 3/8"
Nylock Nut (15).
Press a 2" x 2" Inner Cap (29) into the Base
(69).
12.Attach the Leg Lever (71) to the Leg Press Frame (72) with a 5/16" x 2 3/4" Bolt (3) and 5/16" Nylock Nut (4).
Press a 1 1/2" x 1 1/2" Inner Cap (95) into the Leg Lever (71). Attach the 1" Bumper (31) to the Leg Lever with the 3/4" Screw (32).
Press a 3/4" Round Inner Cap (30) into each end of a Pad Tube (66).
Insert the Pad Tube (66) into the lower end of the Leg Lever (71). Center the Pad Tube and slide a 6" Foam Pad (65) onto each end of it.
13.Apply grease to the pedal axles on the Rear Upright (74).
Press two Pedal Bushings (39) into the Right Pedal (64). Slide the Right Pedal onto the right pedal axle. Note: Make sure that the
Pedal Is on the correct
Plastic Cap (37) against the end of the pedal axle. Make sure that the teeth on the Retainer
Ring bend outward. Tap the Retainer Ring and Plastic Cap onto the pedal axle.
10
11 | The four holes | I'/ |
| ||
| must be on t;_ | /// |
,15
2916
12
Attach the Leg Lever
o 't- _ 7us=ng in=s hole
_ 31 / | II L SJ |
95 _ | v | 6"6 "_ |
13 | J _ |
|
lots
Attach the Left Pedal (63) in the same manner.
