TROUBLE-SHOOTING AND MAINTENANCE
Inspect and properly tighten all parts of the cross training system each time you exercise. Replace any wom parts immediately. The cross training system can be cleaned using a damp cloth and mild non- abrasive detergent. Do not use solvents.
ADJUSTING THE CABLES
If there is too much slack in the cables, the cables can be adjusted. To tighten the cables, find the 5/16" Nylock Nut (4) near the lower end of the Front Upright (76). To tighten the cables, hold the 5/16" x 4" Bolt (27) and turn the Nylock Nut clockwise. If the cables cannot be tightened
enough by turning the Nylock Nut, see the
instructions below.
27
Locate the two 3 1/2" Pulleys (55) attached to the "1" Plates (75). The 'T'Plates have three adjust- ment holes for tightening the cables. Remove the 3/8" Nylock Nut (15) and 3/8" x 1 3/4" Bolt (26) attaching the lower Pulley to the 'T'Plates. Attach the Pulley to the next higher hole in the "1"
Plates. Turn the 5/16" Nylock Nut (4) clockwise umii the cabies are tight (see Orawing i).
If the cables still cannot be tightened enough, see the back cover of this owner's manual to
order new cables.
55 _
21
