Sears 911. 62041, 911. 62078, 911. 62071 Importantinstructionsfor Yoursafety, Tools you will need

IMPORTANTINSTRUCTIONSFOR YOURSAFETY

•Injury To Persons Could i_!i_i

Result	_i_iiiii
• Install Anti-tip	Device _
Packed+ithRange
• See Installation	Instructions

Tools you will need:

Phillips head screwdriver

1 3/8" open end or adjustable wrench

1.Remove the bracket from the prepack located inside the oven.

2.Decide whetherthe bracketwill be installed on the right or left side of range location.

3.If the bracket side of the range is adjacent to a cabinet, place the bracket against back wall and cabinet as shown below.

ADJACENT CABINET OR FINAL
LOCATION OF RANGE SIDE	OUTSIDE EDGE OF
PANEL
	ACKET TO BE
	FLUSH WITH LEFt OR
	RIGHT SIDE OF RANGE
	N
	WALL BEHIND
	RANGE1

If there is no adjacent cabinet, determine where the location of the range side (painted outside panel) will be. Place the bracket with its outside edge at this location and against back wall. See illustration below.

a Determine whether you will anchor the bracket to the floor or waft. Make sure this

location is clear of electrical wiring or plumbing.

1Fasten the bracket securely with the screws provided. Screws are selFdrilling in wood, plywood, particle and chip board, and

most metal framing. If attaching to masonry, you can buy suitable screws and anchors at hardware stores. Use a masonry drill to drill the required holes.

BRACKET		WALL
		PLATE
SCREW MUST ENTER_		/
WOOD OR METAL
illlllP*,**L*lbl..,i	_tll

ATTACHMENT TO WALL

m Using the wrench, back out the four leg levelers at least two turns. See your

installation guide for more leveling information before positioning range.

w Slide the range into place. Be sure rear leg

levelerfullyengagestheslotinthebrackeL If range cannot be moved back far enough for rear leg leveler to enter bracket, move

bracket forward as required and attach to floor in new location.

3