TENANCE
AIR SCREEN
TOP AIR
COVE R
FIGURE 25
.03O" (.762 MM)
FEELER GUAGE
SPARK
PLUG
FIGURE 26
HOSE
AMP
HOSE CL
FUEL
FIGURE 27
5. Lubricate Steering and Front Wheels
There is a grease fitting on each front wheel and axle spindle. Use a grease gun to give each grease fitting two shots of extreme pressure lubricating grease (available through your Sears Service Center)(Fig 24 [
6.Oil Pivot Points
Place several drops of SAE 30 off at points where metal parts move against each other, especially:
aHood hinges..
b_ Shifter shaft points.
SEE LUBRICATION CHART, PAGE 19.
7. Clean Air Screen
Air screen (Fig. 25) must allow
ai/ orwaterpressure to remove dirt, chaff, stubborn dried gum and fibers._
ALWAYS WEAR SAFETY G LASSES WHEN
USING COMPRESSED AIR.
DO NOT TOUCH HOT MUFFLER, CYLIN-
DER OR FINS AS CONTACT MAY CAUSE
BURNS.
8. Inspect Muffler
Inspect and replace corroded muffler as it could create a fire hazard and/or damage (Fig 25)
9o Clean Engine Cooling Fins
Remove any dust, dirt or oil from engine cooling fins to prevent
engine damage from overheating. Air guide covers must be
removed(Fig, 25). Remove bolts to remove side and top covers_ See HOOD REMOVAL, page 21.
[ _ ORDO FINSNOT ASTOUCHCONTACTHOT MUFFLER,MAYCAUSECYLINDERBURNS_ [
Every 100 Hours
DISCONNECT SPARK PLUG WIRES TO
PREVENT ACCIDENTAL STARTING BE-
FORE MAKING ANY INSPECTION, ADJUST-
MENT OR REPAIR (EXCEPT CARBURE-
TOR). BE CAREFUL TO AVOID TOUCHING
HOT ENGINE OR MUFFLER COMPONENTS.
1o Replace Spark Plugs
Replace spark plugs at the beginning of each mowing season or every 100 hours, whichever comes first. Gap should be set at 0 030" (0. 762 mm). (Fig, 26)..
Z Replace Air Cleaner Paper Cartridge
Refer to page 17o
3o Replace
if fuel filter is clogged, obstructing fuel flow to carburetor; replace- ment is required,.
a..With engine cool, remove filter andplug fuelfine sections as removed from both ends of fuel filter (Fig_ 27).
b.Place new fuel filter in position in fuel fine.. Be sure there are no fuel line leaks and that fuel line is in proper position in hose clamps..
BESURETHERE ARE NO FUELLINE LEAKS
AND THAT FUEL LINE iS IN PROPER POSI-
TION IN HOSE CLAMPS.
4.Change Engine Oil Filter
a_ Drain crankcase of oil (refer to "CHANGE ENGINE OIL," page 15, through step d)_ Remove old filter (Fig. 19) by turning counterclockwise°
b_ Before installing new filter, apply a thin coating of oil on surface of the rubber seal
cInstall new filter by turning clockwise until rubber seal contacts the filter adapter, then tighten the filter an additional 1/2 tum_
do Refill crankcase with engine o# (see page 15 for oil specifications). Add an additional 1/2 pint (24 litres) oil for the new filter capacity°
e.Start the engine.. Check for and correct any oil leaks..
18
