REPAIR & ADJUSTMENTS
FRAME CLUTCH WIRE
CONNECTOR
IDLER
TRANSAXLE
PULLEYELECTRIC
CLUTCH
LOCATOR
FIGURE 43
9 Motion Drive Belt Replacement
NOTE: BELT INSTALLATION DECAL IS LOCATED UNDER LEFT FOOTREST
aRemove mower (see "MOWER REMOVAL" page23).
bUsing a 1/2" wrench, remove the clutch Iocator (Fig...43)
cUsingag/16"wrench, Ioosentherighthandbeltkeeper (Fig. 4,3)
dDisconnect clutch wire connector. Push connector through frame (Fig. 431,.
ePull belt off clutching idler' and raise to top side otpultey,
fRelease parking brake Push belt over and away from clutching idler
gPull belt slack toward rear of tractor Remove belt from transmission pulley by deflecting keepers to force belt up and out of pulley. (Use belt to push keepers away from pulley.) (Fig, 43 )
hWork belt around remainingpulleys and keepers, work- ing toward transaxle pulley
jPullbeltforwardoff transaxle pulley and down over electric clutch
h, Reinstall in reverse of above procedure,
Make sure right hand belt keeper' is positioned correctly between
locator tabs and electric clutch connection is secure
10Blade Replacement
Rinse mower _o highest positron fo permi_ access to blades or remove mower
a Remove bolt Iockwasher and washer (F_g 44)
(turn counterclockw_se)(''_)
HEX BOLT _ | """ | LOCK WASHER |
(GRADE 5)
bRemove and discard old blade
cClean top and bo[rom of mower housing
dPlace new blade between flanges, (Install with sharp edge down), and secure with washer, lock- washer and bolt previously removed
11, Tire Care
aMaintain tire pressure in front at 14 PSt (tKg/crrF) and rear tires at 10 PSI (0 7 Kg/cn'F),
b.Keep tPes free of gasofine, oil, or insect control chemicals which can harm rubber:
c Avoid stumps, stones, deep ruts, sharp objects and |
other hazards that may cause tire damage, |
FIGURE 44
HUB
WASHERS
d Removing wheel for tire repair (Fig 45) |
1. Block up axle securely_, |
CAP KLIP
_ RING
SQUARE KEY (REAR ONLY)
FIG URE 45
A GRADE 5 HEAT TREATED BOLT
CAN BE IDENTIFIED BY THREE
LINES ON THE BOLT HEAD AS
SHOWN AT LEFT
2Remove hub cap, klip ring and washer to allow wheel removal (rear wheel contains a square key - Do Not Lose),.
3Repair tire and reassemble.. Align slots in rear
wheel hub and ax/e. Insert square key Replace washer and snap kfip ring securely in axle groove. Replace hub cap.
NOTE: USE GREASE FtTI'INGS TO LUBRICATE FRONT WHEELS WITH GENERAL PURPOSE GREASE APPLY AN
| ALWAYS | USE | GRADE | 5 HEAT | |
| TREATED | BOLTS | TO | ATTACH | |
| CHECK BOLTS IN BLADES OCCASION- | ||||
| BLADES. DONOTUSE | PLATED BOLTS° | |||
| ALLY TO MAKE SURE BOLTS ARE | ||||
24 | TIGHT,, TORQUE | BOLTS TO | |||
( |
|
|
| ||
it ,l_,l
