ASSEMBLY
RETAINER
_ SPRING
/
HINGE
MOWER
PARALLEL LINK
FIGURE 7
SUS.PE NSION
ARMS
REAR HINGE
LiFTjLtFT
TRUNNION t BRACKET
FIGURE8
I_tN' LEVER
PLUNGER
ATTACHMENT CLUTCH
SWITCH (C
PosmoN)
HEIGHT A DJUSTMENT
KNOB
%
ATTACHMENT
UFT LEVER
FIG URE 9
LOWER
| HEIGHT ADJUSTMENT |
|
FIGURE 10 | KNOB | 10 |
6.Mower and Drive Belt Installation
INSTALL MOWER PARALLEL LINK
Your tractor has been shipped with the mower parallel link included in the parts carton, Install mower parallel link on tractor (Fig. 7) using hinge pin and retainer spring,
NOTE: SMALLER END OF PARALLEL LINK MOUNTS
TO TRACTOR USE THE SHORTEST HINGE PIN FOR MOUNTING,
INSTALL MOWER
Your mower installs without the use of tools..
a, Raise attachement lift lever (Fig, 9) to its highest posi- tion,.
b,, Turn height adjustment knob counterclockwise _ ) to lowest position (Fig, 10)
c, Slide mower under tractor with discharge guard to R,.H, side
dInstall rear hinge pin through mower flit brackets and parallel link (Fig. 8), Secure with retainer spring,
eMove attachment lift lever (Fig, 9) forward to lower suspension arms, Remove retainer springs from fift trunnions (Fig, 8)
fSlide trunnions through upper lift bracket holes and secure with retainer springs (Fig 8),
g, Pull L H idter putley (Fig_ 12) toward the right hand side of the tractor and roll belt over engine pulley (Fig, 8)
NOTE: MOWER DRIVE BELT INSTALLATION DECAL LOCATED ON MOWER HOUSING,
h.Use attachment lift lever (Fig 9) to raise mower,,
iTurn height adjustment knob clockwise ([_) to the middle of its travel (Fig 10),
7o Check Cutting Level
The blade housing was set at the factory to cut tevet After mowing a shortdistance, look atthe area that was cut, Iftheblade housing cuts uneven, see "MOWER ADJUSTMENT," page 2I
8.Final Assembly
a Make sure all fasteners are tight.
b., Read and follow the operation instructions (page 1I), Know the location and purpose of all controls,,
c, Check oil and gasoline (page I2) befGre staffing the tractor,
L.H $OLER
NUTPULLEY
MOWER DRIVE
BELT
SPR_NG
IDLER
PULLEY
i
'i
OWERL ;
PULLEY
FIGURE 11