BELT
TRANSAXLE
PULLEY
fl
RETAINER
RETAINERBELT GUIDE
REPLACE TRACTOR MOTION DRIVE BELT
The tractor Drive Belt may be replaced without tools, Park the tractor on level area, Engage Parking Brake, NOTE:
BELT INSTALLATION DECAL UNDER LEFT FOOT-
REST.
a, Remove mower. (See Mower Section, page 20).
b. Remove two Retainer Springs from Belt Guide Bracket below Transaxte Pulteyo Remove Bracket (Fig. 32),.
cSwing Belt Guides away from Belt, toward rear of trac- tor (Fig 32)
dRoll Belt over top of Transaxle Pulley
eRoll Belt over Engine Pulley and off idler IFig 34).
fRelease Parking Brake Pull Belt as far as possible over top of Clutch Pulfey
gReset Parking Brake° Pull Belt over top of Clutch Putley (Fig 34)
hPull Belt out through Shift Gate to remove from tree, tor (Fig 33)
Install Belt by reversing above procedure, NOTE: RE PLACE ONLYWlTH BELT LISTED IN MANUAL,
SPRINGBRACKET
SPRING
FIGURE 32
SHIFT GATE
FIGURE 33
ENGINE
PULLEY /
DRIVE BELT
SCHEMATIC
CLUTCH
PULLEY
4.CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the Battery and Terminals cause the Battery to =_leak" power
PLOSIVE GASES, KEEP SPARKS, FLAME,
AND SMOKING MATERIALS AWAY
FROM BATTERIES ALWAYS SHIELD
YOUR EYES AROUND BATTERIES,
a Disconnect BLACK Battery Cable then RED Battery
Cable and remove Battery from Tractor Wash Battery
with four tablespoons of bak;ng soda to one gallon of
water. NOTE: BE CAREFUL NOT TO GET THE SODA
SOLUTION INTO THE CELLS. Rinse the Battery with plain water, dry and reinstall on Tractor
b, Clean Terminals and Battery Cable ends w:th a w:re
brush unti! bright, Replace Battery Cables, connecting
RED Battery Cable to Pos;tlve Term;nal f rst ;hen
BLACK Battery Cabie to Negat ve Term ha!, Coat tet,.
minal connections with VasoFne:
L.H. SIDE
BELT GUIDE
REAR |
|
VIEWED FROM BOTTOM OF TRACTOR |
|
FIGURE 34 |
