BATTERY ONSTALLATDON
WEAR EYE AND FACE SHIELD..
WASH HANDS OR CLOTHING IMMEDI-
ATELY tF ACCIDENTALLY IN CONTACT
WITH ELECTROLYTE°
DO NOT SMOKE, FUMES FROM CHARG-
ED ELECTROLYTE ARE EXPLOSIVE.
1.Fill and charge Battery (before installing), NOTE: SEE
DETAILED iNSTRUCTIONS PACKAGED WITH BAT- TERY.
ao Fill Battery with electrolyte to bottoms of tubes in cells (Fig, 4). NOTE: DO NOT OVERFILL. OVERFILLING WILL RESULT 1N DAMAGE TO TRACTOR.
b.Check level of electrolyte after 30 minutes° Add addi- tional electrolyte if necessary. NOTE: TIGHTEN VENT CAPS SECURELY_
c.Charge Battery at a rate not exceeding three amperes for about two and one half hours.
do Neutralize excess electrolyte for disposal by adding it to four inches of water in a five gallon plastic contain- er., Stir with a wooden or plastic paddle while adding baking soda until the addition of more soda causes no more foaming.
DO NOT SHORT BATTERY TERMINALS.
BEFORE INSTALLING BATTERY, RE-
MOVE METAL BRACELETS, WRIST-
WATCH BANDS, RINGS, ETC. FROM
YOUR PERSON,,
2Position Battery in tractor as foltows: a. Lift Seat (Fig. 5),
b., Lower Battery into Fender Wel! with Battery Terminals toward front of tractor (Fig, 5),, Make sure Battery rests in Battery Tray (Fig,, 6).
NOTE: BE SURE BATTERY DRAIN TUBE IS SECURE- LY ATTACHED TO BATTERY TRAY DRAIN.
3. Connect Battery Cables using: two Hex Bolts, two Flat
Washers, two Lockwashers and two Hex Nuts (shown full size below) found in Bag of Parts,
CUT AWAY VIEW | VENT CAP |
BATTERY
TUBE
BATTERY
CELL
FIGURE 4
SEAT
FENDER
WELL
POSITIVENEGATIVE
BATTERYI BATTERY
TERMINALTERMINAL
BATTERY
FIGURE 5
POSITIVE TERMINAL MUST BE CON-
NECTED FIRST TO PREVENT SPARKS
F ROM ACCIDENTAL GROUNDING
a Connect RED Battery Cable to Positive (+) Battery Tero
minal with Hex Bolt, Flat Washer. Lockwasher and Hex Nut (Fig. 6). Tighten securely.
b. Connect BLACK Ground Cable to Negative
Terminal with remaining Hex Bolt, Fiat Washer, Lock- washer and Hex Nut (Fig° 6). Tighten securely°
