LIFT
PLUNGER
LIFT
LEVER
SI
TOP OF
FLANGETOP OF
FLANGE
AA
FIGURE 15
ADJUSTMENT
TRUNNION
FIGURE 16
\ | REAR | |
SUSPENSION | ||
ARM | ||
|
i_REAR
/FLANGE
D
REARFRONT
SUSPENSION LIFTFLANGE
TRUNNIONBRACKET
FIGURE 17
REAR
NUTSUSPENSION
ARM
REAR
SUSPENSION
TRUNNIONLIFT
BRACKET
NUT "F"
LEVEL MOWER FROM SIDE TO SiDE
SEE MOWER ADJUSTMENT, PAGE 9.
t_ Park tractor on level surface_ Depress Lift Lever Plunger and use Lift Lever to raise mower to maximum cutting height,
,Measure height of Top of Flange to level surface at front of
,It _t
mower. D_stance A should be the same (Fig. I5)o
m If distance "A" needs to be changed, snap out Access Hole
Cover on LHo side above Footrest. Use 9/16" wrench on Nuts "B" and "C" at
4_ To raise left side of mower, loosen Nut m*Bm'and tighten
Nut "Ctl_
e To lower left side of mower, loosen Nut "C" and tighten Nut "B'o
NOTE: ONE ROTATION OF ADJUSTMENT NUTS IS
EQUIVALENT TO APPROXIMATELY 3/16" HEIGHT CHANGE,
. Be sure all nuts are securely tightened°
NOTE: SEE MOWER ADJUSTMENT,
ADJUST MOWER FROM FRONT TO REAR
,To obtain the best cutting results, your Mower Housing should be adjusted so the Front and Rear Flange distance "D" (Fig_ 17) is 5/16" lower in front when the mower is
positioned in the hinhest cutting position._ NOTE: MEAS-
URE DISTANCE _XD_ FROM SURFACE TO RIGHT REAR FLANGE AND COMPARE TO DISTANCE "D" AT
RIGHT FRONT FLANGE°
2, To raise rear of mower, loosen Nut "E" on both Rear SuE- pension Arms. Screw both Nuts "F" up EQUAL NUMBER OF TURNS (Fig= 18)_
3.When distance "D" is 5/1B" lower at front than rear, tight_ en Nut "E'o
4.To lower rear of mower, loosen Nut "F" on both Rear
Suspension Arms an EQUAL NUMBER OF TURNS (Fig.
18).
5_ When distance S'D" is 5t16" lower at front than rear, re= tighten Nuts _'E'.
NOTE: WHEN ADJUSTING REAR SUSPENSION TRUN- NIONS, ALWAYS ADJUST BOTH EQUALLY SO MOWER WILL STAY LEVEL.
FIGURE 18 | .10 - |
