INaTIAL SERVnCE
NOTE: BE CAREFUL NOT TO ALLOW DiRT TO ENTER THE ENGINE WHEN CHECKING OR ADDING OIL OR FUEL
I.,Open Hood.
2.Check Engine Oil Leve! with Tractor on level ground Re- move and wipe Dipstick (Fig, 9) clean, screw it in tight for a few seconds, remove and read Oil Level if necessary, add
Oil until "FUEL" mark is reached
RECOMMENDED SAE VISCOSITY GRADES
f .....sw2o0._w3o' | L!i,!ii!I | !....z | ||
|
| |||
....I.... | ti: |
| ||
| 0° | 32 ° | 60 ° 80 ° | 100 ° |
TEMPERATURE RANGE EXPECTED BEFORE NEXT OIL CHANGE° ALL OILS MUST MEET A.P.L SERVICE CLAS- SIFICATION SD, SE, OR SF,.
Capacity is 2 pints° NOTE: DO NOT OVERFILL Dipstick assembly must be securely tightened into tube at all times
when engine is operating.
3.Fill Fuel Tank (Fig.. 9). Use fresh, clean, unleaded auto- motive gasoline° (Leaded "Regular " grade gasoline" "ts not an acceptable substitute° Use of leaded gasoline wilt increase carbon and lead oxide deposits and reduce valve life). Capacity is 5 quarts..
WARNING: DO NOT USE GASOHOL OR METHANOL. These type fuels react with water content in the fuel
and tend to form strong acids which can corrode metal parts and harm rubber and plastics.
FILL TO BOTTOM OF GAS TANK FILLo
ER NECK, DO NOT OVERFILL. WIPE
OFF ANY SPILLED OIL OR FUEL, DO
NOT STORE, SPILL OR USE GASOLINE
NEAR AN OPEN FLAMEn
OIL FILLER
FUEL
CAP
FUEL
TANK
FIGURE 9
