Sears 917.28858 To Check Brake, Front Wheel Toe-In/Camber, To Remove Wheel For Repairs

Models: 917.28858

1 36
Download 36 pages 6.58 Kb
Page 29
Image 29
TO CHECK BRAKE

FRONT WHEEL TOE-IN/CAMBER PRECAUCIÓN: La palanca de levantamiento estáaccionadaporresorte.Sosténgalafirmemente apretada, bájela lentamente y engánchela en la posición más baja. La palanca de levantamiento se encuentra en el lado izquierdo de la defensa.

Palanca De

Levantamiento

2.ARME LA RUEDA CALIBRADORA DELAN- TERA (W) EN LA PARTE DELANTERA DE LA CORTADORA DE CÉSPED

H

W

X

Z

Y

H.Escuadra De La Cortadora De Césped Delantera

W.Rueda Calibradora Delantera

X.Perno Con Resalto

Y.Arandela De 1-1/4

Z.Tuerca De Seguridad De 3/8-16

3.GIRE EL VOLANTE HACIA LA IZQUIERDA Y UBIQUE LA CORTADORA DE CÉSPED EN SU LUGAR

Gire el volante completamente hacia la izquierda y ubique la cortadora de césped en el lado derecho del tractor con el blindaje deflector (Q) a la derecha.

Parte Delantera

Motor

Q

 

 

 

02965

Transeje

 

 

 

Parte Trasera

Q. Blindaje Deflector

4.DESLICE LA CORTADORA DE CÉSPED DEBAJO DEL TRACTOR

Lleve la correa hacia adelante y verifique que su trayectoria sea correcta en todos los surcos de la polea de la cortadora de césped.

NOTA: Asegúrese de que los brazos de susp- ensión lateral de la cortadora de césped (A) estén orientados hacia adelante antes de deslizar la cortadora de césped debajo del tractor.

Deslice la cortadora de césped debajo del tractor hasta que se encuentre centrada debajo del tractor.

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

2.Disengage transmission by placing freewheel control in “transmission dis- engaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manually push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a Sears or other qualified service center.

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and cam- ber is set at the factory and is normal. The front wheel toe-in and camber are not adjust- able. If damage has occurred to affect the factory set front wheel toe-in or camber, con- tact a Sears or other qualified service center.

TO REMOVE WHEEL FOR REPAIRS

1.Block up axle securely.

2.Remove axle cover, retaining ring and washers to allow wheel removal (rear wheels have a square key - Do not lose).

3.Repair tire and reassemble.

NOTE: On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

TO START ENGINE WITH A WEAK BAT- TERY

TO REMOVE WHEEL FOR REPAIRS WARNING: Lead-acid batteries gener- ate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure: IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES

1.Connect one end of the RED cable to the POSITIVE (+) terminal of each battery(A- B), taking care not to short against tractor chassis.

2.Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

3.Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER

1.BLACK cable first from chassis and then from the fully charged battery.

2.RED cable last from both batteries.

B

M F

4. Replace washers and snap retaining ring

securely in axle groove.

L A TO START ENGINE WITH A WEAK BAT- TERYManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background W

KManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background E

C

 

 

H

 

 

 

I

 

 

 

C

 

 

 

A. Brazos De Suspensión Lateral

S

D

Q

 

De La Cortadora De Césped

 

 

 

B. Resorte De Retención

 

I. Escuadra Trasera Izquierda De La

 

C. Eslabones De Levantamiento Traseros

 

 

D. Escuadra Trasera Derecha De La Cortadora

 

Cortadora De Césped

 

De Césped

 

K. Varilla Tensora De La Correa

 

E. Conjunto De Eslabones De Levantamiento

 

L. Escuadra De Bloqueo

 

Delanteros

 

M. Polea Del Embrague Del Motor

 

F. Escuadra De Suspensión Delantera

 

Q. Blindaje Deflector

 

H. Escuadra De La Cortadora De Césped

 

S. Barra Antibalanceo

 

Delantera

 

W. Rueda CalIbradora Delantera

 

5. Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, purchase and use tire sealant from Sears. Tire sealant also prevents tire dry rot and corrosion.

Washers

Retaining

Ring

Axle Cover

Square Key (Rear

Wheel Only)

Weak or Dead

Fully Charged

Battery

Battery

44

29

Page 29
Image 29
Sears 917.28858 owner manual To Check Brake, Front Wheel Toe-In/Camber, To Remove Wheel For Repairs