ESSEX ELECTRONICS, INC.
KE-265 Series
All rights reserved. No part of this documentation may be reproduced in any form, without prior written consent of Essex Electronics, Inc. Essex Electronics shall not be liable for errors contained in this manual. The information in this document is subject to change without notice. Essex Electronics, Inc. reserves the right to modify this documentation and to make improvements or changes to the product(s) contained in this documentation at any time.
Document Information
IOMKE265.0406.Rev D
Installation/Operations Manual for
This documentation is applicable to the
Trademarks
Keyless Entry® is a registered trademark of Essex Electronics, Inc. Lexan® is a registered trademark of General Electric Co., USA.
Contact Information
Essex Electronics, Incorporated
1130 Mark Avenue
Carpinteria, CA 93013
(805)
Website: keyless.com
General email: essex@keyless.com
Technical Support email: support@keyless.com
Copyright ©
Table of Contents |
|
INTRODUCTION | 2 |
OVERVIEW | 2 |
SYSTEM SPECIFICATIONS | 2 |
INPUT REQUIREMENTS | 3 |
OUTPUT CAPABILITIES | 3 |
KEYPAD OPTIONS | 4 |
PREPARING FOR INSTALLATION | 5 |
SYSTEM COMPONENTS | 5 |
THE INSTALLATION PROCEDURE | 6 |
REQUIRED TOOLS | 6 |
PREPARE THE KEYPAD FOR INSTALLATION | 6 |
INSTALL THE WIRING CABLE | 8 |
MOUNT THE KEYPAD | 8 |
PREPARE THE DOOR FOR THE ELECTRIC STRIKE | 8 |
INSTALLING THE CONTROL MODULE | 8 |
CONNECTING THE LOCKING DEVICE | 9 |
BATTERY BACKUP | 9 |
SYSTEM HARDWARE SETUP | 10 |
REMOTE | 10 |
10 | |
SETTING RELAY OPTIONS | 10 |
TAMPER ALARM LOCKOUT | 13 |
SYSTEM PROGRAMMING | 14 |
OVERVIEW OF SYSTEM CODE PROGRAMMING | 14 |
OVERVIEW OF THE MASTER CODE | 14 |
PROGRAMMING THE MASTER CODE | 15 |
OVERVIEW OF USER CODES | 15 |
PROGRAMMING USER CODES | 16 |
PROGRAMMING DOOR OPEN TIME | 16 |
TROUBLESHOOTING | 18 |
REPAIRS AND WARRANTY | 20 |
REPAIR POLICY | 20 |
WARRANTY | 21 |
APPENDIX A – CIRCUIT BOARD LAYOUT | 23 |
APPENDIX B - TYPICAL WIRING DIAGRAMS | 24 |
NOTES | 25 |
1
