Security 100 KE-265 manual System Programming, Overview of System Code Programming

System Programming

Overview of System Code Programming

There are TWO levels of codes for the KE-265 system.

1.The Master Code (used to open the door and for programming User Codes)

2.User Codes (used by personnel to open the door)

IMPORTANT: Notes to remember before programming:

1.All codes must be 3 to 8 digits.

2.All codes must be different from each other.

Note: 5-Pad Keypads have two digits on each pad. The system reads these numbers as the same.

For example: 1-3-5-7-9 is the same as 2-4-6-8-0.

3.Do not program codes, which are part of other codes. For example: User Code 1 Î 1-2-3-4-5 and User Code 2 Î 1-2-3

4.During programming, the system resets after 5 seconds if a number is not entered. Do not let more than 5 seconds elapse between entries or the system will reset and you will have to start over.

Overview of the Master Code

Knowledge of the Master Code is the highest privilege granted to a user of the KE-265 system. There is only one master code, which is used to program each of the 5 User Codes. The factory default Master Code, “1-3-5-7-9”, can be used for initial programming but should be changed to a unique 3 to 8 digit code.

The Master Code can be configured to activate either Relay #1 or Relay #2 depending on how the system hardware is set up (see Setting Relay Options Î page 10). However, the Master Code cannot be configured to Latch either relay.

Programming the Master Code

To Program/Change the Master Code:

1.Select a 3 to 8 digit code that will be used for the Master Code.

___ ___ ___ ___ ___ ___ ___ ___

2.Locate the Control Module, remove the cover and locate the “PROGRAM” switch on the circuit board.

3.Press the PROGRAM switch once *. (The Keypad will beep rapidly 4 times)

4.At the Keypad, enter 1-1-1-9 to open the memory (you will hear three rapid beeps) and immediately enter your new Master code.

(Do not let more than five seconds elapse between entries or the system will reset!!!)

5.After entering your new code, wait five seconds for the 3 reset beeps.

*Once the PROGRAM switch has been pressed, you have 2 minutes to begin programming.

Overview of User Codes

There are a total of 5 User codes (also called Secondary Codes) that can be programmed into the KE-265. User Codes can vary in length from 3 to 8 digits. Each User Code is programmed into one of 5 User Locations. These Locations are as follows:

User # User Location User Code 1 Î 1-1-1 User Code 2 Î 1-1-3 User Code 3 Î 1-1-5 User Code 4 Î 1-1-7 User Code 5 Î 1-1-9

Once a User Code has been programmed into a User Location, the User Code can be easily changed or deleted from the system (see Programming User Codes). Latching and User Code Unlocking Authorization is determined by how each relay is configured. (see Setting Relay Options Î page 10)

14 15