-If group is omitted, shows this screen.
-If group is specified, shows 'set' command usage of the group. factorydefault [option] + <CR>
-if option is omitted, all parameters are set with factory default values.
-if
all parameters except IP settings are set with factory default values. save + <CR>
-Save changes exit + <CR>
-Exit without rebooting the device reboot + <CR>
-Exit and reboot the device
Figure 2-15 Help screen
> help ip
set ip ipmode par1 par2 ...
-ipmode: static=Static IP / dhcp=DHCP / pppoe=PPPoE
-parameters:
if ipmode = static, par1 = IP address, par2 = subnet mask, par3 = gateway
if ipmode = dhcp,
no parameters required if ipmode = pppoe,
par1 = PPPoE username, par2 = PPPoE password
Figure 2-16 Help screen with ‘ip’ group specified
2.4.4 ‘factorydefault’ Command
With ‘factorydefault’ command, users can load factory default parameter values in console. Command usage of ‘factorydefault’ is as follows:
factorydefault [option] + <CR>
where,
-if option is omitted, all parameters are set with factory default values.
-if
Loaded values are not saved until ‘save’ command invoked. After ‘factorydefault” command, ‘save’ and ‘reboot’ commands are required for changes to take effect.
>factorydefault (or factorydefault
OK
>save
OK
> reboot
Figure 2-17 Factory default reset screen
21