Senatek LS100 manual IP Address Configuration, IP configuration parameters

3: IP Address Configuration

A valid IP address of the LS100 needs to be assigned before it starts to work in the user's network environment. A network system administrator may provide the user with this IP address setting information for the network. The IP address must be unique within the network. Otherwise, the LS100 will not have a valid connection to the network.

Users can choose the desired IP mode out of the three IP operating modes, i.e., Static IP, DHCP and PPPoE. The factory default IP mode is DHCP mode. Table 3-1 shows the parameter items for IP configuration.

	Table 3-1 IP configuration parameters
Static IP		IP address
		Subnet mask
		Default gateway
DHCP		No parameters required
PPPoE		PPPoE username
		PPPoE password

Basic ‘set’ command usage for IP configuration is as follows:

set ip ipmode par1 par2 ...

where,

ipmode: ‘static’ for Static IP / ‘dhcp’ for DHCP / ‘pppoe’ for PPPoE parameters:

if ipmode = static,

par1 = IP address, par2 = subnet mask, par3 = gateway if ipmode = dhcp,

no parameters required if ipmode = pppoe,

par1 = PPPoE username, par2 = PPPoE password

23