Senatek LS100 manual Connecting the Hardware, Connecting the Power, Connecting to the Network

2.2 Connecting the Hardware

This section describes how to connect the LS100 to serial device for the first time test.

-Connect the power to the LS100

-Connect the Ethernet cable between the LS100 and Ethernet hub or switch

-Connect the serial data cable between the LS100 and a serial device

2.2.1 Connecting the Power

Connect the power jack to the LS100 power jack using DC power adapter included in the package. If the power is properly supplied, the [Power] lamp of the LS100 will maintain solid red.

Figure 2-2. Connecting the power to the LS100

2.2.2 Connecting to the Network

Connect the one end of the Ethernet cable to the LS100 10Base-T port and the other to the Ethernet network. If the cable is properly hooked up, the LS100 will have a valid connection to the Ethernet network by indicating:

-[Link] lamp of the LS100 maintains solid green

-[Act] lamp continuously blinks to indicate the incoming/outgoing Ethernet packets

If any of the above does not happen, the LS100 is not properly connected to the Ethernet network.

12