If problems occur ...
Error checklist
Problem | Possible cause | Possible solution |
|
|
|
No | Batteries are flat or | Replace the batteries |
operation | accupack is flat | or recharge the |
indication |
| accupack |
|
|
|
No RF signal | Transmitter and | Set transmitter and |
| receiver are not on the | receiver to the same |
| same channel | channel |
|
|
|
| Transmitter is out of | Check the squelch |
| range | threshold setting |
|
| or change the position |
|
| of the transmitting |
|
| antenna |
|
|
|
RF signal | Receiver’s squelch | See “Adjusting the |
available, | threshold is adjusted | squelch threshold – |
no audio | too high | SQELCH” on page 25 |
signal, |
|
|
Transmitter does not | Set the transmitter to | |
“MUTE” | transmit a pilot tone | stereo operation or |
display |
| deactivate the pilot |
appears on |
| tone evaluation on the |
the display |
| receiver |
panel |
|
|
|
|
|
No access to | During scanning, an RF | See “Scanning the |
a certain | signal has been | channel bank for free |
channel | detected on this | channels – SCAN” on |
| channel and the | page 25 |
| channel has been |
|
| locked |
|
|
|
|
If problems occur that are not listed in the above table or if the problems cannot be solved with the proposed solutions, please contact your local Sennheiser agent for assistance.
31
