Sennheiser EM300 manual 43

Adjustment tips and functions

Advanced Menu	Adjusting the contrast of the display panel
Tune			PEAK0	Advanced Menu				PEAK0		LCD Contrast				PEAK0		LCD Contrast
Sync Settings	40					40						40
				Warnings							Tune					Tune
Pilot Tone		30	-10				30	-10					30	-10
																	15
		20	-20	LCD Contrast			20		-20		7		20		-20
Warnings		10	-30	Reset			10	-30			Hotsync		10	-30		Hotsync
			-40		7			-40						-40
LCD Contrast		RF	AF				RF		AF				RF		AF
													Store the setting
Reset		Call up “LCD					Select the desired
IP-Address		Contrast”					setting
Software Revision

Exit

“Stored”

Advanced Menu

Tune

Sync Settings

Pilot Tone

Warnings

LCD Contrast

Reset

IP-Address

Software Revision

Exit

You can adjust the contrast of the display panel in 16 steps.

Resetting the settings made in the operating menu

40	PEAK0		Advanced Menu	40		PEAK0		Reset		40		PEAK0		Reset
			LCD Contrast						Tune
30	-10				30	-10					30	-10			Tune
			Reset
20		-20			20		-20		No		20		-20		Yes
	-30		IP-Address			-30			Hotsync					Hotsync
10					10						10	-30
RF	-40					-40						-40
		AF			RF		AF				RF		AF
Call up “Reset”					Select the desired						Store the setting
					setting

“Stored”

When resetting the settings made in the operating menu, only the selected settings for the pilot tone and for the frequency banks “U1” to “U6” remain unchanged. For an overview of the factory-preset default settings, refer to the supplied frequency information sheet.

Advanced Menu

Tune

Sync Settings

Pilot Tone

Warnings

LCD Contrast

Reset

IP-Address

Software Revision

Exit

Adjusting the network configuration

		PEAK		Advanced Menu				PEAK		IP-Address				PEAK	IP-Address
40		0		Factory Reset		40		0			Manual	40		0		Manual
	30	-10					30	-10					30	-10
										192.168.178.100
20			-20	IP-Address			20		-20		192.168.178.100			20	-20
10		-30		Software Revision			10	-30					10	-30
		-40						-40						-40		MAC: 00-11-D8-B0-F4-33
					192.168.178.100					MAC: 00-11-D8-B0-F4-33
RF			AF				RF		AF				RF	AF
Call up “IP-Address”							Select the mode and						Enter the IP address;
							confirm						store the setting

“Stored”

You can either automatically allocate or manually enter an IP address. This menu item also shows the receiver’s unique and unchangeable MAC address.

In order to ensure safe communication between receivers in multi-channel systems (see page 45), we recommend using automatic allocation of IP addresses.

42