Sennheiser qp 3041 Putting the Quadpack into operation, Mounting the plastic feet

Putting the Quadpack into operation

D

Q R R Q

Mounting the plastic feet

To ensure that the Quadpack cannot slip on the surface on which it is placed, four self-adhesive plastic feet are supplied.

Note:

Do not use these feet if rack-mounting the Quadpack!

EEnsure that the base of the Quadpack is clean and free from grease before mounting the plastic feet.

EFix the plastic feet to the base of the Quadpack by peeling off the safety paper and fitting them as shown in the diagram on the left.

Attention!

Some furniture surfaces have been treated with varnish, polish or synthetics which might cause stains when they come into contact with other synthetics. Despite a thorough testing of the synthetics used by us, we cannot rule out the possibility of discoloration, since we don’t know your furniture.

Mounting the EK 3041 receivers into the Quadpack

The EK 3041 receivers are inserted into the receiver slots and fixed by means of four screws.

EUnscrew the two antennas of the receiver.

EIf necessary, remove the sub-D adapter mounted to the receiver.

EInsert the receiver completely into the receiver slot as shown in the dia- gram on the left.

EFix the receiver to the receiver slot by fastening the screws to the four holes Q.

EScrew the right-angled plugs of the two antenna cables onto the two antenna sockets R of the receiver.

Note:

The mounted receivers are automatically turned on if the Quadpack is turned on. The control LEDs D next to the mounted receivers light up. Unused receivers can be turned off via their respective ON buttons.

23