Sennheiser qp 3041 instruction manual No monitoring signal available

The transmitters are turned off or the transmitters are not within the reception area:

ETurn the transmitters on and make sure that there is a “free line of sight” between the transmitters and the receiving antennas. If the receiver position is not the best antenna position for optimum reception, use remote antennas (see „Accessories” on page 31).

No monitoring signal available

All control LEDs for the receivers light up red – no receiver has been selected:

EPress one or several monitor keys. The control LEDs of the selected receivers light up green.

The headphone volume control is turned fully counter-clockwise:

ESlowly turn the headphone volume control clockwise.

Audio signal is too low or slightly noisy or distorted

The audio signal is too low or distorted – the output level of the Quadpack has not been adapted to the input of the mixing console or amplifier:

EUse the MIC-LINEselector switches and the AF output level controls to adapt the output levels of the AF outputs to the inputs of your mixing console or amplifier.

Please also observe the notes given in the receiver’s instruction manual!

The monitoring signal is distorted – the volume at the monitor output is adjusted too high so that the headphone amplifier is overmodulated:

EUse the headphone volume control to reduce the volume at the monitor output.

Note:

The monitor output has enough amplification headroom in order to enable monitoring even at low modulation levels.

30