Using the transmitter

Using the transmitter

To establish a transmission link, proceed as follows:

1.Switch the transmitter on (see below).

2.Switch the receiver on (see the instruction manual of the receiver). The transmission link is established.

It is vital to observe the notes on frequency selection on page 21.

If you cannot establish a transmission link between transmitter and receiver:

￿Make sure that transmitter and receiver are set to the same frequency bank and to the same channel.

￿If necessary, read the chapter “If a problem occurs ...” on page 23.

Switching the transmitter on/off

To switch the transmitter on (online operation):

￿Press the STANDBY button .

The transmitter switches on and the standard display appears.

The transmitter transmits an RF signal and the transmission icon is displayed

You can switch the transmitter on and deactivate the RF signal on switch-on. For more information, see below.

To switch the transmitter to standby mode:

￿If necessary, deactivate the lock mode (see page 18).

￿Keep the STANDBY button  pressed until “OFF” appears on the display panel. The display panel switches off.

When in the operating menu, pressing the STANDBY button will cancel your entry (ESC function) and return you to the standard display.

The STANDBY button is backlit in red both during operation and in standby mode.

To completely switch the transmitter off:

￿Disconnect the transmitter from the mains by unplugging the mains unit from the wall socket.

The backlighting of the STANDBY button  goes off.

To switch the transmitter on and to deactivate the RF signal on switch-on(offline operation): ￿ Press the STANDBY button until “RF Mute On?” appears on the display panel.

￿ Press the jog dial.

The transmission frequency is displayed but the transmitter does not transmit an RF signal. The transmission icon  is not displayed.

13