Using the transmitter

Use this function to prepare a transmitter for use during live operation without causing interference to existing transmission links.

To activate the RF signal:

￿Briefly press the STANDBY button .

RF Mute Off” appears on the display panel.

￿ Press the jog dial.

The transmission icon  is displayed again.

Monitoring the audio signal via headphones

You can monitor the audio signal via the headphone output.

CAUTION! Danger of hearing damage!

Listening at high volume levels for long periods can lead to permanent hearing defects.

￿ Set the headphone volume control to the minimum position before putting the headphones on.

￿ Set the headphone volume control to the minimum position.

￿ Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output . ￿ Gradually increase the volume and monitor the audio signal with the lowest possible

volume.

Synchronizing transmitters and receivers via the infra-red interface

Easy Setup Sync function (EK 300 IEM G3 -> SR 300 IEM G3)

Once you have performed a frequency preset scan with your EK 300 IEM G3 diversity receiver (see the instruction manual of the receiver), you can use the Easy Setup Sync function to transfer unused frequency presets from the receiver to the transmitters via the infra-red interface. The diversity receiver transfers the first unused channel from the current frequency bank to the first transmitter and the next unused channel to the second transmitter and so on.

Sync function (SR 300 IEM G3 -> EK 300 IEM G3)

On the other hand, you can use the Sync function to adjust settings for your EK 300 IEM G3 diversity receiver directly on your SR 300 IEM G3 rack-mount transmitter and transfer theses settings to the receiver via the infra-red interface.

Via the “Sync Settings” submenu, you can adjust the parameters listed below and activate or deactivate their transfer to the receiver (see page 20).

14