OPERATION
Never work under the Implement, the framework, or any lifted component unless the Implement is securely supported or blocked up to prevent sudden or inadvertent falling which could cause serious injury or even death.
5.1 Setting Deck Height
LEVELING DECK CENTER SECTION
1.Place the tractor and mower on a level surface and lower both wings.
2.Use the center section hydraulic cylinder to set the mower at approximately 3/4” above the desired cutting height. The additional height is necessary so that after the mower has been leveled, the deck pitch can be set such that the front of the mower is slightly lower than the rear.
3.Shut down the tractor, place the transmission in park, and set the parking brake before dismounting.
4.Level the mower deck front to rear by adjusting the leveling rods linking the tongue to the rear axle. DO NOT allow feet or other body part underneath the mower when making adjustments. To adjust rod length, loosen jamnut and screw turnbuckles. To lower the front, lengthen the rods and to raise the front, shorten the rods. DO NOT unscrew turnbuckles to the point that either rod threaded ends becomes disconnected which will cause the mower to fall.
5.IMPORTANT: Alternate adjustments between rods and adjust at equal lengths to maintain equal tension. Improper adjustments may cause rods to snap or bend.
6.Place split collar assemblies on the center axle hydraulic cylinder rod to maintain a set
cutting height each time the mower is raised and lowered.
Operation Section |
© 2011 Alamo Group Inc.
