ASSEMBLY
ASSEMBLY
When attaching the Implement input driveline to the Tractor PTO, it is important that the connecting yoke spring activated locking collar slides freely and the locking balls are seated securely in the groove on the Tractor PTO shaft. Push and pull the driveline back and forth several times to ensure it is securely attached. A driveline not attached correctly to the Tractor PTO shaft could come loose and result in personal injury and damage to the Implement.
DRIVELINE ATTACHMENT
The driveline yoke and tractor PTO shaft must be dirt free and greased for attachment.
To connect the mower driveline to the tractor PTO output shaft, pull the driveline yoke collar back and align the grooves and splines of the yoke with those of the PTO shaft. Push the driveline yoke onto the PTO shaft, release the locking collar, and position the yoke until the locking collar balls are seated onto the PTO shaft. Push and pull the driveline back and forth several times to ensure a secure attachment.
Many of the equipment components are HEAVY (60 lbs or greater) and Special Lifting Procedures are recommended. Use lifting assistance such as mechanical assistance, two people, and proper lifting techniques when connecting or installing the driveshaft to reduce the possibility of back injuries.
1.Remove bolts from main driveline implement connection yoke and insert onto power divider gearbox shaft. Install bolts according to driveline clamp yoke instructions in this section.
2.Inner center axle dual tire assemblies are shipped bolted on wing mount tubes. Remove transport bars from wings and lower each wing so that inner tire and hub assembly can be removed and installed on center axle. NOTE: It will be necessary to raise each side of center axle slightly so inner dual tires can be installed.
3.Install gearbox vents or vent dipsticks if not installed.Check all gearbox lube levels.
Assembly Section |
© 2011 Alamo Group Inc.
