ASSEMBLY
ASSEMBLY
ATTACHING AXLE ASSEMBLIES TO MAIN WHEEL BAR TUBE
•Mark desired row spacing with chalk on wheel bar. Keep outer axle assemblies as close to each end of the shredder to balance load and prevent scalping. Fasten axle assemblies (item 1) to wheel bar (item 2) with clamp plate (item 3) and four 3/4" bolts (item 4), lockwashers and nuts (items 5,6). Tighten bolts evenly and progressively torque to 200 ft. lbs. RC12 is shipped standard with two Axle Assemblies.
•Attach ratchet screw jack, (Rhino p/n 00554600) between cylinder bracket mount and ear on rear of center plate.
ATTACHING OPTIONAL HYDRAULIC CYLINDER
(P/N 00725933)
•Attach clevis end of hydraulic cylinder (item 1) to mount bracket (item 2) and attach barrel end to rear mount on center plate.
RC12 | Assembly Section |
© 2005 Alamo Group Inc.
