OPERATION
OPERATION
RHINO RC12 FLAIL SHREDDER OPERATION
INSTRUCTIONS
.
READ AND UNDERSTAND THE ENTIRE OPERATING INSTRUCTIONS AND SAFETY SECTION OF THIS MANUAL AND THE TRACTOR MANUAL BEFORE ATTEMPTING TO USE THE TRACTOR AND MOWER. If you do not understand any of the instructions, contact your nearest authorized dealer for a full explanation. Pay close attention to all safety signs and safety messages contained in this manual and those affixed to the cutter and tractor.
READ, UNDERSTAND, and FOLLOW the following Safety Messages. Serious injury or death may occur unless care is taken to follow the warnings and instructions stated in the Safety Messages. Always use good common sense to avoid hazards.
The RC Flail is primarily designed to shred crop residue such as cotton stalks, corn, rice straw, milo, rye grass and similar crops. Shredder should be operated at 1000 PTO RPM only, at a ground speed of 2 to 5 mph. Only trained personnel who are familiar with the safety and operating procedures should operate this equipment.
Refer to tractor operating instructions for correct engine RPM and gear selection. Always wear a seatbelt on tractors equipped with roll over protection. Exercise extra caution when operating on uneven ground. Never leave tractor seat while mower or tractor are operating. Always slow tractor to an idle, disengage PTO and wait for all rotation to cease. Apply parking break and shut off engine before dismounting.
RC12 12/05 | Operation Section |
© 2005 Alamo Group Inc.
