SHUTTING DOWN AND CLEAN-UP
STEP 1: Remove detergent suction tube from container and insert into one gallon of fresh water. Open de- tergent metering valve. Pull trigger on spray gun and siphon water for one minute. Close detergent valve.
Engine |
Switch |
STEP 2: Turn off the engine.
STEP 3: Turn off water supply.
Water
Inlet
STEP 4: Press trig- STEP 5: Disconnect the garden ger to release water hose from the water inlet on the
pressure.machine.
High |
Pressure |
Outlet |
STEP 6: Disconnect the high pressure hose from high pres- sure outlet.
Safety |
Latch |
STEP 7: Engage the spray gun safety lock.
STORAGE
PRESSURE WASHER OPERATOR’S MANUAL
CAUTION: Always store your pressure washer in a location where the temperature will not fall below 32°F (0°C).The pump in this machine is susceptible to permanent damage if frozen. FREEZE DAMAGE IS NOT COVERED BY WARRANTY.
1.Stop the pressure washer, squeeze spray gun trig- ger to release pressure.
2.Detach water supply hose and high pressure hose.
3.Turn on the machine for a few seconds, until re- maining water exits. Turn engine off immediately.
4.Drain the gas and oil from the engine.
5.Do not allow high pressure hose to become kinked.
6.Store the machine and accessories in a room which does not reach freezing temperatures.
CAUTION: Failure to follow the above directions will result in damage to your pressure washer.
When the pressure washer is not being operated or is being stored for more than one month, follow these instructions:
1.Replenish engine oil to upper level.
2.Drain gasoline from fuel tank, fuel line, fuel valve and carburetor.
3.Pour about one teaspoon of engine oil through the spark plug hole, pull the starter grip several times and replace the plug.Then pull the starter grip slowly
until you feel increased pressure which indicates the piston is on its compression stroke and leave it in that position. This closes both the intake and ex- haust valves to prevent rusting of cylinder.
4.Cover the pressure washer and store in a clean, dry place that is well ventilated away from open flame or sparks. NOTE: The use of a fuel additive, such as
After Extended Storage
CAUTION: Prior to restarting, thaw out any possible ice from pressure washer hoses, spray gun or wand.
Engine Maintenance
During the winter months, rare atmospheric conditions may develop which will cause an icing condition in the carburetor. If this develops, the engine may run rough, lose power and may stall. This temporary condition can be overcome by deflecting some of the hot air from the engine over the carburetor area. NOTE: Refer to the engine manufacturer's manual for service and mainte- nance of the engine.
11
SHARK SSG •
