Shark SSG-503027E, SSG-503027G, SSG-503537E, SSG-503537G, SSG-603537E, SSG-603537G Wand Collar

ASSEMBLY INSTRUCTIONS

Spray

Gun

Safety

Latch

High Pressure

Hose

Pressure

Nozzle

Wand

Coupler

Pressure

Nozzle

Wand

Coupler

Wand

Collar

STEP 1: Attach the high pressure hose to the spray gun using teflon tape on hose threads.

Dipstick

STEP 4: Remove shipping cap and install oil dipstick. Check pump oil level by using dipstick or observe oil level in oil window (if equipped). Use 30 wt. non detergent oil.

STEP 2: Pull the spring-loaded col- lar of the wand coupler back to in- sert your choice of pressure nozzle.

High Pressure

Hose

Discharge

Fitting

Coupler

Collar

STEP 5: Connect the high pressure hose to the pump discharge fitting. Push coupler collar forward until secure.

STEP 3: Release the coupler col- lar and push the nozzle until the collar clicks. Pull the nozzle to make sure it is seated properly.

Cold

Water

Source

Garden

Hose

STEP 6: Connect garden hose to the cold water source.

PRESSURE WASHER OPERATOR’S MANUAL

Water

Inlet

Garden

Hose

STEP 7: Check inlet filters, remove debris, then connect the garden hose. CAUTION: Do not run the pump without water or pump dam- age will result.

SHARK SSG • 97-6134 • REV. 7/05a

7