Shark SSG-503027E, SSG-503027G, SSG-503537E, SSG-503537G, SSG-603537E, SSG-603537G Coil Removal

OPERATOR’S MANUAL PRESSURE WASHER

14

MAINTENANCE

Coil Removal:

Removal of coil because of freeze breakage, or to clean soot from it can be done quickly and easily.

1.Disconnect hose from pump to inlet side of the coil.

2.Carefully disconnect the thermostat sensor mak- ing sure you do not crimp the capillary tube.

3.Remove burner assembly from combustion cham- ber.

4.Remove the 3-3/8" bolts from each side of coil and tank assembly (these bolts are used to fasten tank to chassis).

5.Remove fittings connected to the 1/2" pipe nipples from inlet and discharge sides of coil.

6.Remove top tank wrap, bend back insulation tabs and fold back blanket.

7.Remove bolts that hold down coil to bottom wrap.

8.Remove coil.

9.Replace or repair any insulation found to be torn or broken.

10.Remove insulation retainer plates.

Coil Reinstallation:

Reinstall new or cleaned coil by reversing Steps 9 through 1.

SHARK SSG • 97-6134 • REV. 7/05a