Shark SSG-503027E, SSG-503027G, SSG-503537E, SSG-503537G, SSG-603537E, SSG-603537G manual Nozzles

OPERATING INSTRUCTIONS

Burner

Temperature

Control

PRESSURE WASHER OPERATOR’S

STEP 8: Pull the starter grip. If the engine fails to start after 2 pulls, squeeze the trigger gun to release pres- sure and repeat step. Return starter gently. After the engine warms up enough to run smoothly, move choke to run position and throttle to fast position.

CAUTION: Small engines may kick back. Do not hold pull starter grip tightly in hand.

STEP 9: Turn the burner “ON”.Turn temperature con- trol dial to the 210° mark.

MANUAL

NOZZLES

The four color-coded quick connect nozzles provide a wide array of spray widths from 0° to 45° and are easily accessible when placed in the con- venient rubber nozzle holder, which is provided on the front of the ma- chine.

NOTE: For a more gentle rinse, se- lect the white 40° or green 25° nozzle. To scour the surface, select the yel- low 15° or red 0° nozzle.To apply de- tergent select the black nozzle.

Safety

Latch

WARNING! Never replace nozzles without engaging the safety latch on the spray gun trigger.

STEAM COMBINATION

Steam Valve

Thermostat

Burner Switch

Step 1: For steam, open the steam	Step 2: Turn the thermostat knob to	Step 3: To stop, reverse steps. Set
valve counterclockwise.	the 270° mark, (The thermostat is a	all controls to their original settings.
This lowers the pressure and raises	high limit device and does not regu-	Step 4: Turn burner switch off, open
the temperature.	late temperature.	trigger on spray gun and allow water
	SHARK SSG • 97-6134 • REV. 7/05a	to cool.

9