Sharp 70LE745U, 70LE847U Appendix, Attaching the Stand for LC-80LE844U, Stand Unit Assembly

Appendix

Attaching the Stand (for LC-80LE844U)

•Before attaching (or detaching) the stand, unplug the AC cord.

•Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.

CAUTION

•Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.

•After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the TV.

•Do not remove the stand from the TV unless using a wall mount bracket to mount it.

Before attaching the stand to the TV, build a work table on which to rest the TV.

• To build the table, use the cushioning materials used in the packaging.

TOP-R

TOP-L

TOP-C

•Of the cushioning materials used, TOP-C is also used during stand unit assembly. Be sure to assemble the stand unit before building the work table.

■Stand Unit Assembly

1Confi rm that there are 12 screws (8 long screws and 4 short screws) supplied with the stand unit.

21Set the post for the stand unit onto the TOP-C. 2Attach the base to the post.

3Insert and tighten the 8 screws into the 8 holes on the bottom of the base.

•Hold the stand unit securely with one hand, and then tighten the screws.

4The case is equipped with push-in tabs to hold the cushioning materials in place. Push in the tabs (2 for each location) to secure the cushioning materials in the case.

Push-in tabs

5After you have built the work table, spread a blanket or similar soft cloth over the table and then lay the TV display down on the covered table.

•Do not use a small table for this.

■Attaching the Stand to the TV

6Insert the stand into the openings on the bottom of the TV.

•Make sure that the stand is fi rmly inserted into the TV. Improper installation may result in tilting of the TV set.

2

1

3

Long screws

1

FRONT

7Insert and tighten the 4 screws into the 4 holes on the rear of the TV.

■Building the Work Table

3Insert each of the cushioning materials in the respective directions shown in the fi gure.

•Insert TOP-L and TOP-R into the left and right sides of the case respectively.

•Insert TOP-C to fi t between the lines on the other side of the case.

TOP-R

Short screws

•In the installation procedure, be careful not to catch your fi ngers between the TV set and the fl oor.

TOP-L

CASE

LINE

TOP-C

79