Reduces toner consumption by approximately 10%.
Power save modesThe unit has two power save modes of operation: preheat mode and auto power
When the unit enters the preheat mode, the power save ( 
) indicator will light up and other indicators will remain on or off as before. In this condition, the fuser in the unit is maintained at a lower heat level, thereby saving power. To copy from the preheat mode, make desired copier selections and press the start ( 
) key using the normal copying procedure.
When the unit enters the auto power 
) indicator will light up and other indicators except the ONLINE indicator will go out. The auto power 
) key. Then make desired copier selections and press the start ( 
) key using the normal copying procedure.
The unit returns to the initial settings a preset amount of time after the end of job. This preset amount of time (auto clear time) can be changed.
Resolution of AUTO & MANUAL modeYou can set the copy resolution used for AUTO and MANUAL ( 
) exposure mode.
When enabled, this function may help prevent wasteful use of toner that occurs when the OC cover is not completely closed.
If the start ( 
) key is pressed when the OC cover is not completely closed, " 
" will appear in the display and copying may not take place. If copying does not take place, copying can be performed by pressing the start ( 
) key again, however, the scan size set in "Copy effective paper width setting function" (program numbers 25, 26, 27) will be used.
If the OC cover is completely closed after " 
" appears, copying will take place at the normal size.
) mode.2 Press and hold down the exposure mode selector key for approximately 5 seconds.
| The MANUAL ( | ) indicator will go out |
| and the PHOTO ( | ) indicator will begin |
to blink. The light and dark indicator marked "5" will light up, indicating the standard toner mode is active.
54