Sharp AL-2030, AL-2040CS STATUS INDICATORS

STATUS INDICATORS

When the following indicators light up or blink on the operation panel or the following alphanumeric codes appear in the display, solve the problem immediately referring to both the table below and the relevant page.

Be sure to use only genuine SHARP parts and supplies.

Indication		Cause and remedy	Page
Drum replacement	Steadily	Replacement of drum cartridge will be needed	71
	lit	soon. Prepare a new cartridge.
required indicator
	Blinking	Drum cartridge must be replaced. Replace it with a new one.	58
TD cartridge	Steadily	Replacement of TD cartridge will be needed	71
replacement	lit	soon. Prepare a new cartridge.
required indicator	Blinking	TD cartridge must be replaced. Replace it with a new one.	57
Misfeed indicator	Blinking	A misfeed has occurred. Remove the misfed paper	63
		referring to the description of "MISFEED REMOVAL".
	Steadily	When the document feeder cover is open.	–
SPF misfeed	lit
		An original misfeed has occurred in the SPF.
indicator
	Blinking	Remove the misfed originals referring to the	67
		description of "E: Misfeed in the SPF".
		The unit is in the preheat mode. Press any key to	54
		cancel the preheat mode.
Power save indicator is
		The unit is in the auto power shut-off mode.
steadily lit.
		Press the start ( ) key to cancel the auto power	54
		shut-off mode.
The paper tray indicator is		The paper tray is not pushed in correctly, or there
		is no paper in the tray. Push the tray all the way	–
blinking.
		in or load paper in the tray.
"CH" is blinking in the display.		The TD cartridge is not installed. Check if the	57
		cartridge is installed.

"CH" is steadily lit in the

Side cover is open. Close the side cover securely

display.

by pressing the round projections near the side – cover open button.

This appears if it is detected that the OC cover is open when copying is started. Completely close the OC cover, or press the start () key again.

"OP" is blinking in the display. Depending on the color and the density of the – original, "OP" blinking may appear even when

the OC cover is closed. In such a case, press the start key again to make a copy.

	The paper tray or multi-bypass tray is empty.	15, 17
	Load paper.
"P" is blinking in the display.
	A misfeed has occurred in the paper tray or	63
	multi-bypass tray. Remove the misfed paper.
A letter and a number appear	The scan head locking switch is locked. Unlock	9
alternately.	the scan head locking switch.
A letter and a number appear	The unit will not function. Turn the power switch
	off, remove the power cord from the outlet, and	–
alternately.	contact our Technical Assistance Department at
	1-(630)378-3590 in the USA.

62