USER SETTINGS
135
Print mode *The scanning speed increases when the USB 2.0 mode is set to "HI-SPEED",
however, the printing speed does not increase considerably.
Program
number Program name
Setting codes
(factory default
setting appears
in bold)
Explanation
1FORCED
OUTPUT
1: ON
2: OFF
When this function is enabled,
printing in printer mode will
automatically continue using a
different size of paper if the
specified size of paper runs out in
all trays. This feature does not
function in copy mode.
2USB 2.0 MODE
SWITCH *
1: FULL-SPEED
2: HI-SPEED
This sets the USB 2.0 data transfer
speed. To obtain the fastest speed
when using the USB 2.0 connector,
first verify that your computer
meets the system requirements
(operating system and driver), and
then use this program to change
the USB 2.0 mode to "Hi-Speed".
Note that the setting should not be
changed while running a TWAIN
driver. (For the system
requirements, see "System
requirements for USB 2.0 (Hi-
Speed mode)" (p.58).)
3AUTO TRAY
SWITCH
1: ON
2: OFF
This is selectable when the
optional paper tray is installed.
(This is not shown when the
optional tray is not installed.)
4ENABLE TCP/
IP
1: ON
2: OFF
This is to select whether or not to
make the network connection by
TCP/IP protocol effective.
5 ENABLE DHCP 1: ON
2: OFF
This is to select whether or not to
apply to DHCP network
connection.
6IP ADDRESS
SETTING
1:IP ADDRESS
2:
SUBNETMASK
3: DEFAULT
GATEWAY
This is to set IP address,
Subnetmask and Default Gateway
from the machine. This can also
be used to check the machine’s IP
ADDRESS when "IP ADDRESS" is
selected. When the program
number 5 "ENABLE DHCP" is "ON"
and the machine is under DHCP
environment, the IP address on the
display is shown with " " at the
tail end.