29
AN-PR1000_EN.fm06/3/14
AN-PR1000H
TINSEA127AWZZ
2
3
4
5
6
7
8
1
Advanced Features
Using the Auto Station Programme Memory (ASPM)
Whilst in the ASPM operation mode, the tuner will automatically search for new RDS
stations. Up to 40 stations can be stored.
If you have already stored some stations in memory, the number of new stations you
can store will be less.
To stop the ASPM operation before it is complete:
Press the RDS ASPM button whilst it is scanning for stations.
The stations which are already stored in memory will be kept there.
Notes:
If the same station is broadcasting on different frequencies, the strongest
frequency will be stored in memory.
Any station which has the same frequency as one stored in memory will not be
stored.
If 40 stations have already been stored in memory, the scan will be aborted. If you
want to redo the ASPM operation, erase the preset memory.
If no stations have been stored in memory, "END" will appear for about 4 seconds.
If the RDS signals are very weak, station names may not be stored in memory.
To erase all of the contents of preset memory:
To store a station name again if the wrong name was stored in memory:
It may be impossible to store station names in memory using the ASPM function if
there is lots of noise or if the signal is too weak. In this case, perform as follows.
Notes:
The same station name can be stored in different channels.
In a certain area or during certain time periods, the station names may temporarily
be different.
Notes for RDS operation
If any of the following events occur, it does not mean that the unit is
faulty:
"PS", "NO PS" and a station name appear alternately, and the unit does not operate
properly.
If a particular station is not broadcasting properly or a station is conducting tests,
the RDS reception function may not work properly.
When you receive an RDS station whose signal is too weak, information like the
station name may not be displayed.
"NO PS" or "NO PTY" will flash for about 5 seconds, and then the frequency will be
displayed.
1Press the TUNER button to select the FM stereo band.
2Press the SHIFT button, and then hold down the RDS ASPM button
for at least 3 seconds.
1 After "ASPM" has flashed for about 4 seconds, scanning will start (87.50 -
108.00 MHz).
2 When an RDS station is found, "RDS" will appear for a short time and
station will be stored in memory.
3 After scanning, the number of stations stored in memory will be displayed
for 4 seconds, and then "END" will appear for 4 seconds.

TUNER

ASPM

SHIFT

TUNER

ASPM

1 Hold the CLEAR button down for 4 seconds or more.
2 Within 10 seconds, press the SHIFT and ENTER buttons.
After performing this operation, all of the preset memory information will be erased.
1 Hold down the SHIFT button and press the PRESET
( or ) button to check
whether the names are correct.
2 If you find a wrong name during receiving the station, wait until the correct name
will be displayed and then press the SHIFT and ENTER buttons.
3 Within 5 seconds, press the SHIFT and ENTER buttons whilst the preset channel
number is flashing.
The new station name has been stored in memory correctly.