Sharp AR-M205, AR-M160 operation manual Printer Function

APPENDIX

	000" (W) x 000" (D) x 000" (H) (590 mm	000" (W) x 000" (D) x 000" (H) (590 mm
Dimensions	(W) x 545 mm (D) x 470 mm (H)) (using	(W) x 545mm (D) x 555mm(H)) (using
	document cover and including toner	document cover and including toner
	cartridge)	cartridge)
Operating conditions	Temperature: 00°F - 00°F (15°C- 30°C) Humidity: 20% - 85%
	Sound power level LwA(1B=10dB)
	In operation: 6.3[B]
	On standby: 3.9[B]
	Sound pressure level LpA (bystander position)
Noise level	In operation: 49[dB(A)]
	On standby: 24[dB(A)]
	Sound pressure level LpA (operator position)
	In operation: 00[dB(A)]
	On standby: 00[dB(A)]
	Measured according to ISO7779
Emission concentration	Ozone: 0.02 mg/m3 or less, Particulate matter: 0.075 mg/m3 or less
(measured according to
	Styrene: 0.07 mg/m3 or less
RAL-UZ62)
	Dual function board (AR-EB7)
Optional equipment	250-sheet paper feed unit (AR-D24)
	2 x 250-sheet paper feed unit (AR-D25)
	Single pass feeder (AR-SP6)
	Reversing single pass feeder (AR-RP6)

*The first copy time and warmup time may vary depending on the power source voltage, temperature, and other environmental conditions.

Printer Function

Print speed	16 ppm (21 ppm when ROPM enabled, Dual function board must be installed)
First print*	7.2 sec.
Resolution	600 dpi
IMC memory	16 MB
Two-sided printing	Yes (AR-M205)
function
Paper feed method	Same as for copying
Offset function	Offsets each print job
Supported operating	Windows 95/98/Me, Windows NT 4.0 Workstation, Windows 2000 Professional
	Windows XP Home Edition/Professional
systems
	(Detailed information can be found in the SOFTWARE SETUP GUIDE)
Emulation	SHARP GDI
	Up to 256 MB can be added by installing a 32 MB, 64 MB, 128 MB or 256 MB
Expansion memory	expansion memory module (168-pin SDRAM DIMM) in one DIMM expansion slot
	(Dual function board must be installed)
	Maximum of 272 MB including IMC memory.
Port	IEEE1284 parallel port/
	USB port (USB1.1), USB port (USB2.0, Dual function board must be installed)
	[Parallel cable]
	Shielded bi-directional (IEEE1284) cable (max. length 3 m)
	Please purchase a commercially available parallel cable.
Interface cables	[USB cable (only for connection to USB 1.1 port)]
	Shielded twisted pair cable (max. length 3 m)
	[USB cable (only for connection to USB 2.0 port)]
	Shielded twisted pair cable (max. length 3 m, must support USB 2.0)
	Please purchase a commercially available USB cable.

*The first print time and warmup time may vary depending on the power source voltage, temperature, and other environmental conditions.

76