Sharp CD-DD4500 operation manual Listening to a Cassette Tape TAPE 1 or TAPE

Listening to a Cassette Tape (TAPE 1 or TAPE 2)

Tape Playback – Listening to a Cassette Tape (TAPE 1 or TAPE 2) –

Before playback:

For playback, use normal or low-noise tape for the best sound. (Metal or CrO2 tape is not recommended.)

Do not use C-120 tapes or poor-quality tapes, as they may cause malfunctions.

Before loading a tape into the cassette compartment, tighten the slack

with a pen or pencil.

Playback is possible in TAPE 1 compartment as well as in TAPE 2.

1 Press the POWER button to turn the power on.

2 Open the cassette door by pushing the area marked “ 7 PUSH

EJECT”.

3 Load the cassette into the TAPE 1 or TAPE 2 cassette compartment with the side to be played facing toward you.

TAPE 1 TAPE 2

4 Press the TAPE (1 V 2) button to select the cassette you want to listen to.

5 Press the 0/R ( 0 ) button to start playback.

To stop playback:

Press the ■ (TAPE ■) button.

Fast forward/rewind: (TAPE 2 only)

1.Press the ■ (TAPE ■) button, then press the TAPE (1 V 2) button to select TAPE 2.

2.To advance the tape, press the W PRESET 2 4 ( 2) button. To rewind it, press the 5 3 PRESET X ( 3 ) button.

Caution:

To remove the cassette, press the ■ (TAPE ■) button, and then open the compart- ment.

Before changing from one tape operation to another, press the ■ (TAPE ■) button. If a power failure occurs during tape operation, the tape head will remain engaged with the tape and the cassette door will not open. Wait until the power is restored.

24 Sound Control (See page 16.)