Sharp CD-DD4500 operation manual Sleep operation, Advanced Features - Timer and Sleep Operation

6 Press the TUNING/TIME (W or X) button to specify the minute, then press the MEMORY/SET button.

7 The unit will enter the timer stand-by mode automatically.

To cancel the timer playback/timer recording:

Press the POWER button to turn the power on.

8 When the preset time is reached, playback or recording will start.

The volume will increase gradually until it reaches the volume you were listen- ing at before your system enters the timer stand-by mode.

9 In timer playback:

If you select CD or TAPE, the unit will enter the stand-by mode after the playback. If you select TUNER or DVD/VCR, it will enter the stand-by mode one hour after the timer playback starts.

In timer recording:

When recording tape reaches its end, the timer recording will end, and the unit will enter the stand-by mode.

The timer playback/timer recording setting will be canceled if any other op- eration than volume control is performed during its operation.

■Sleep operation

1 Play back the desired sound source.

2 Press the TIMER/SLEEP button repeatedly until “SLEEP” is dis- played.

To change the sleep time:

While the sleep time is displayed, press the TUNING/TIME (X or W) button.

(Maximum: 3 hours - Minimum: 1 minute)

●3 hours - 5 minutes → 5-minute intervals

●5 minutes - 1 minute → 1-minute intervals

3 Press the MEMORY/SET button.

4 Your system will enter the power stand-by mode automatically after the preset time has elapsed.

The volume will be turned down 1 minute before the sleep operation finishes.

To cancel the sleep operation:

Press the POWER button while sleep operation is performed.

To confirm the remaining sleep time:

Press the TIMER/SLEEP button while sleep operation is performed. The remaining sleep time is displayed for about 5 seconds.

Note:

Once the sleep time is set, it will remain unchanged until the setting is changed.

CD-DD4500

Advanced Features – Timer and Sleep Operation –

To reset or change the timer setting:

Perform “Timer playback or Timer recording” from the beginning.

Notes:

●Once the time is set, the setting will be retained until a new time is entered.

●When performing timer playback or recording using another unit connected to the VIDEO/AUX IN or DIGITAL IN jacks, select “DVD/VCR” in step 2. At this time, only this unit will be turned on or enter the power stand-by mode automatically. (Another unit will not be turned on or turned off.)

■ Listening to the Radio (See page 22.) 37