Sharp DK-KP95PH operation manual System connections, Remote control

System connections

Make sure to unplug the AC power lead before making any connections.

Wall socket

(AC 220 - 240 V ~ 50/60 Hz)

■Aerial connection

Supplied FM aerial:

Connect the FM aerial wire to the FM 75 OHMS socket and position the FM aerial wire in the direction where the strongest signal can be received.

External FM aerial:

Use an external FM aerial (75 ohms coaxial cable) for better reception. When an external FM aerial is used, disconnect the supplied FM aerial wire.

Supplied AM loop aerial:

Connect the AM loop aerial to the AM and earth (GND) terminals. Position the AM loop aerial for optimum reception. Place the AM loop aerial on a shelf, etc., or attach it to a stand or a wall with screws (not supplied).

Installing the AM loop aerial:

<Assembling>	<Attaching to the wall>
	Wall	Screws
		(not supplied)

External FM	FM aerial
antenna for better
reception (not
supplied)

AM loop aerial

Note:

Placing the aerial on the unit or near the AC power lead may cause noise pickup. Place the aerial away from the unit for better reception.

■AC power connection

After checking all the connections have been made correctly, plug the AC power lead of this unit into the wall socket.

Note:

Unplug the AC power lead from the wall socket if the unit will not be in use for a prolonged period of time.

■Demonstration (Network stand-by) mode

●The first time the unit is plugged in, the unit will enter the demonstration mode. (refer page 8)

●To cancel the demonstration mode, press the DEMO button (remote control) during power stand-by mode. The unit will enter the low power consumption mode.

●To return to the demonstration mode, press the DEMO button again.

●If iPod or iPhone is docked, the unit will begin charging. “Charge Mode” will be displayed. Demonstration mode is invalid during charge mode.

Remote control

■Battery installation

1Open the battery cover.

2Insert the supplied battery according to the terminal indicated in the battery compartment.

When inserting or removing the battery, push it towards the

(–) battery terminals.

3Close the cover.

Caution:

●Remove the battery if the unit will not be used for a long period of time. This will prevent potential damage due to battery leakage.

●Do not use rechargeable battery (nickel-cadmium battery, etc.).

●Installing the battery incorrectly may cause the unit to malfunction.

●Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

Notes concerning use:

●Replace the battery if the operating distance is reduced or if the operation becomes erratic. Purchase an “AA” size battery (UM/ SUM-3, R6, HP-7 or similar).

●Periodically clean the transmitter on the remote control and the

sensor on the unit with a soft cloth. E-4

●Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.

●Keep the remote control away from moisture, heat, shock, and vibrations.

■Test of the remote control

Check the remote control after checking all the connections. Point the remote control directly at the remote sensor on the unit. The remote control can be used within the range shown below:

Remote sensor

0.2m - 6 m (8" - 20' )