Remote control
HT-SB500
Battery installation
1Insert pin into the hole as shown and pull to open the battery holder.
Pin
Back of remote
control
2Remove the old battery from the battery holder, insert the new battery and then slide the battery holder back into the remote control.
Battery holder
Battery type
Locking tabPositive (+) side up Polarity (+) symbol
Precautions for battery use:
Remove the battery if the speaker will not be used for a long period of time. This will prevent potential damage due to battery leakage.
Caution:
Do not use rechargeable battery
Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Installing the battery incorrectly may cause the speaker to malfunction.
Notes concerning use:
Replace the battery if the operating distance is reduced or if the operation becomes erratic. Purchase “CR 2025”, coin lithium battery.
Periodically clean the transmitter on the remote control and the sensor on the speaker with a soft cloth.
Exposing the sensor on the speaker to strong light may interfere with operation. Change the lighting or the direction of the speaker if this occurs.
Keep the remote control away from moisture, heat, shock, and vibrations.
Test of the remote control
Point the remote control directly at the remote sensor on the speaker.
The remote control can be used within the range shown below:
Press the
Remote sensor
0.2 m - 6 m | 15° 15° |
(8” - 20’) |
ENGLISH
Preparation for Use
