Sharp HT-SB500 Subwoofer level control, Center speaker level control, Bass control, Function

HT-SB500

General control (continued)

ENGLISH

Basic Operation

E-17

Subwoofer level control

The speaker level can be adjusted.
To increase the level, press the
SUBWOOFER LEVEL	button.
To decrease the level, press the
SUBWOOFER LEVEL	button.	-5 -4 ... +4 +5

Note:

When sound from the speaker is distorted, decrease the subwoofer level.

Center speaker level control

The center speaker level can be adjusted.
To increase the level, press the CENTER
SPK LEVEL		button.
To decrease the level, press the CENTER
SPK LEVEL		button.	-5 -4 ... +4	+5
	Bass control
1.	Press the BASS/TREBLE button
	to select “BASS”.
2.	Within 5 seconds, press the
	VOLUME (+ or –) button to adjust
	the bass.		-5			+5
	Treble control
1.	Press the BASS/TREBLE button
	to select “TREBLE”.
2.	Within 5 seconds, press the
	VOLUME (+ or –) button to adjust
	the treble.		-5		+5

Touch Sensing off mode

During Stand-by mode, press the DIMMER/SENS ON/OFF button on the remote control and the on/stand-by indicator will turn from ORANGE to RED.

To turn the power on, press the ON/STAND-BY button on the remote control or touch the ON/STAND-BY pad on the display panel.

Function

On the speaker:

When the FUNCTION pad on speaker LINE 1

is touched, the input source will change.

Touch the FUNCTION pad on speaker
repeatedly to select desired input	LINE 2
source.
On remote control:
Press the LINE 1-2 button repeatedly to
select “L1” (LINE IN 1 input) or “L2”	DIGITAL 1
(LINE IN 2 input).
Press the DIGITAL 1-2 button
repeatedly to select “D1” (DIGITAL IN 1	DIGITAL 2
input) or “D2” (DIGITAL IN 2 input).

Note:

The backup function will protect the memorized function mode for a few hours should there be a power failure or the AC power lead becomes disconnected.

Auto power on function:

When you press the LINE 1-2 or DIGITAL 1-2 button on the remote control, the speaker will turn on at last function.

Auto power off and auto detect signal:

If no analogue signal is detected within 1 minute or if “D1”/ “D2” display is blinking for 30 seconds during power on, the speaker will automatically go to stand-by mode. The on/ stand-by indicator turns ORANGE.

The speaker will automatically power ON if it detects audio signal from connected equipment.

Note:

Make sure to turn off any source/signal input to speaker before going to stand-by mode because it will cause the speaker to power ON again.