Sharp JB965 Care and cleaning of the range, Operating, How to Remove Packaging Tape, Oven Vent

Models: JB965 JB960 JB940 JBP85

1 40
Download 40 pages 61.18 Kb
Page 27
Image 27
Care and cleaning of the range.

Care and cleaning of the range.

Be sure all controls are off and all surfaces are cool before cleaning any part of the range.

If your range is removed for cleaning, servicing or any reason, be sure the anti-tip device is re-engaged properly when the range is replaced. Failure to take this precaution could result in tipping of the range and cause injury.

Safety Instructions

How to Remove Packaging Tape

To assure no damage is done to the finish of the product, the safest way to remove the adhesive left from packaging tape on new appliances is an application of a household liquid dishwashing detergent, mineral oil or cooking oil.

Apply with a soft cloth and allow to soak. Wipe dry and then apply an appliance polish to thoroughly clean and protect the surface.

NOTE: The plastic tape (on some models) must be removed from all chrome trim. It cannot be removed if it is baked on.

Operating

Groove Stem

Molded rib

Spring clip

Clear groove in stem

Control Knobs

The control knobs may be removed for easier

check the OFF position to insure proper

cleaning.

placement.

Before removing the knobs for cleaning,

Wash the knobs in soap and water or a

please note that the knobs are in the

vinegar and hot water solution but do

OFF position. When replacing the knobs,

not soak.

 

 

The knob stem has a groove in each

Replace the knob by fitting the molded

side. The groove on one side has a

rib inside the knob into the clear

spring clip. The other groove is clear

groove on the stem.

(see illustration). Check the inside of

 

the knob and find the molded rib.

 

Instructions Care and Cleaning

Flat Stem

The knob stem is flat on one side (see

Replace the knob by fitting the molded

Molded flat area

illustration). Check the inside of the

flat area inside the knob onto the flat

knob and find the molded flat area.

area of the stem.

 

Flat

Troubleshooting

Oven Vent

The oven vent is located behind the right rear surface unit.

This area could become hot during oven use.

It is normal for steam to come out of the vent and moisture may collect underneath it when the oven is in use.

The vent is important for proper air circulation. Never block this vent.

Tips

Control Panel

Deactivate the touch pads before cleaning.

See the Cooking/Self-Clean lockout information in the Special features of your oven control section in this manual.

Clean up splatters with a damp cloth.

You may also use a glass cleaner.

Remove heavier soil with warm soapy water. Do not use abrasives of any kind.

Reactivate the touch pads after cleaning.

See the Cooking/Self-Clean lockout information in the Special features of your oven control section in this

manual.27

Customer Service

Page 27
Image 27
Sharp JB965, JBP85 Care and cleaning of the range, Operating, How to Remove Packaging Tape, Control Knobs, Oven Vent, Tips