Sharp LC-15B5M, LC-20B5M operation manual Basic Operation, Sound Volume Changing Channels

Basic Operation (Continued)

Sound Volume Changing Channels

■To adjust the volume

You can select channels using Channel Select or CH ( )/( ).

• To handle the increasing number of channels available, this LCD TV set allows you to select up to 100 positions (Channels 0 to 99). One-digit and two-digit methods of selection can be used. Follow the procedure shown below to select channels.

●Press VOL (+) to increase the sound volume. The numerical value increases.

Volume 50

●Press VOL (–)to decrease the sound volume. The numerical value decreases.

Volume 10

■To mute the sound

●Press e (Mute) to temporarily turn off the sound. The MUTE mark is displayed on the screen.

●Press e (Mute) or VOL (+)/(–)to turn the sound back to the previous level. MUTE is automatically cleared when one of the following buttons are pressed: POWER, VOL (+)/(–)or e (Mute).

Volume 10

■Using Channel Select

To select a one-digit channel (e.g., Channel 5):

1	Press 5 of Channel Select.
2	If “5-” is indicated and the picture does not change,
	press -/--to switch over to the 1-digit select mode
	and press 5 of Channel Select.
		1
		PAL
		B/G

To select a two-digit channel (e.g., Channel 15):

1 Press -/--to set the 2-digit select mode.

--

2 Press 1 of Channel Select.

1-

3 Press 5 of Channel Select.

15

PAL

B/G

NOTE

•Complete this procedure within 4 seconds, otherwise the selection will not be made.

Changing channels with CH ()/() on the remote control.

Press CH ( ) and the channels change in the order shown below: 1 → 2 → 3 → . . . → 98 → 99 → 0 → 1 → 2 → 3 → . . .

Press CH ( ) and the channels change in the order shown below: 3 → 2 → 1 → 0 → 99 → 98 → . . . → 3 → 2 → 1 → . . .

■Using A (FLASHBACK)

●Press A to switch the currently tuned channel to the previously tuned channel.

●Press A again to switch back to the currently tuned channel.

11