Sharp LC-32SV29U, LC-46SV49U, LC-26SV490U operation manual Antenna is connected to the television

IMPORTANT SAFETY INSTRUCTIONS

17)Damage Requiring Service—Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a)When the AC cord or plug is damaged,

b)If liquid has been spilled, or objects have fallen into the product,

c)If the product has been exposed to rain or water,

d)If the product does not operate normally by following the operating instructions.

Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation,

e)If the product has been dropped or damaged in any way, and

f)When the product exhibits a distinct change in performance - this indicates a need for service.

18)Replacement Parts—When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.

19)Safety Check—Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

20)Wall or ceiling mounting—When mounting the product on a wall or ceiling, be sure to install the product according to the method recommended by the manufacturer.

CAUTION

•These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.

• Outdoor Antenna Grounding — If an outside

antenna is connected to the television

EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE, ANSI/NFPA 70

equipment, be sure the antenna system is

grounded so as to provide some protection

against voltage surges and built-up static

charges.

Article 810 of the National Electrical Code,

ANSI/NFPA 70, provides information with

regard to proper grounding of the mast

and supporting structure, grounding of the

lead-in wire to an antenna discharge unit,

size of grounding conductors, location

of antenna-discharge unit, connection to

grounding electrodes, and requirements for

the grounding electrode.

GROUND

CLAMP

ELECTRIC

SERVICE

EQUIPMENT

ANTENNA

LEAD IN WIRE

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

GROUNDING

CONDUCTORS

(NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING ELECTRODE SYSTEM

(NEC ART 250)

NEC — NATIONAL ELECTRICAL CODE

•Warning statement indicating that Class I apparatus shall be connected to a mains socket outlet with a protective earthing connection.

•Statement indicating that when the mains plug or appliance coupler shall remain readily operable.

•Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.

•Where an all-pole MAINS SWITCH is used as the disconnect device, the location on the apparatus and the function of the switch shall be described, and the switch shall remain readily operable.

4