Appendix

Troubleshooting

Problem

Possible Solution

 

 

• No power.

• Check if you pressed POWER on the remote control unit. (See page 14.)

 

If the indicator on the TV lights up red, press POWER.

 

• Is the AC cord disconnected? (See page 7.)

 

• Has the power been turned on? (See page 14.)

 

 

• Unit cannot be operated.

• External influences such as lightning, static electricity, etc., may cause improper

 

operation. In this case, operate the unit after first turning the power off the TV or

 

unplugging the AC cord and re-plugging it in after 1 or 2 minutes.

 

 

• Remote control unit does not

• Are batteries inserted with polarity (e, f) aligned? (See page 6.)

operate.

• Are batteries worn out? (Replace with new batteries.)

 

• Are you using it under strong or fluorescent lighting?

 

• Is a fluorescent light illuminated to remote control sensor?

 

 

• Picture is cut off.

• Is the image position correct? (See page 31.)

 

• Are screen mode adjustments such as picture size made correctly? (See pages

 

32 and 33.)

 

 

• Strange colour, light colour, or

• Adjust the picture tone. (See pages 26 to 28 and 35.)

dark, or colour misalignment.

• Is the room too bright? The picture may look dark in a room that is too bright.

 

 

• Check the colour system setting. (See pages 22 and 37.)

 

• Check the input signal setting. (See page 36.)

 

 

• Power is suddenly turned off.

• The unit’s internal temperature has increased.

 

Remove any objects blocking vent or clean.

 

• Check the power control setting. (See page 29.)

 

• Is sleep timer set? (See page 17.)

 

 

• No picture.

• Is connection to other equipment correct? (See pages 41 to 43)

 

• Has input signal setup been done correctly after connection? (See page 36.)

 

• Is the correct input selected? (See page 36.)

 

• Is picture adjustment correct? (See pages 26 to 28.)

 

• Is the antenna connected properly? (See page 9.)

 

• Is “On” selected in “Audio Only”? (See page 35.)

 

 

• No sound.

• Is the volume too low? (See page 17.)

 

• Make sure that headphones are not connected. (See page 12.)

 

 

Cautions regarding use in high and low temperature environments

When the unit is used in a low temperature space (e.g. room, office), the picture may leave trails or appear slightly delayed. This is not a malfunction, and the unit will recover when the temperature returns to normal.

Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight or near a heater, as this may cause the cabinet to deform and the LCD panel to malfunction.

Storage temperature: –20°C to +60°C.

44

Page 45
Image 45
Sharp LC-32AX3X, LC-37AX3X operation manual Appendix, Troubleshooting, Problem Possible Solution