Sharp LC-60LE650U Attaching the Stand for the 80 Inch Models, Building the Work Table

Attaching the Stand (for the 80 Inch Models)

Building the Work Table

Before attaching the stand to the TV, build a work table on which to rest the TV.

•To build the table, use the cushioning materials used in the packaging.

•Of the cushioning materials used, TOP-C is also used during stand unit assembly. Be sure to assemble the stand unit before building the work table.

TOP-R

TOP-L

TOP-C

1 Insert each of the cushioning materials in the	3 After you have built the work table, spread a
respective directions shown in the fi gure.	blanket or similar soft cloth over the table and
• Insert TOP-L and TOP-R into the left and right	then lay the TV display down on the covered
sides of the case respectively.	table before attaching the stand to the TV.
• Insert TOP-C to fi t between the lines on the other	• Do not use a small table for this.
side of the case.	• Refer to the operation manual for information on
TOP-R	attaching the stand.

TOP-L	CASE
	LINE

TOP-C

2The case is equipped with push-in tabs to hold the cushioning materials in place. Push in the tabs (2 for each location) to secure the cushioning materials in the case.

Push-in tabs

1Confi rm that there are 14 screws (8 long screws, 4 middle screws and 2 short screws) supplied with the stand unit.

2Attach the supporting post for the stand unit onto the base as shown below.

•The supporting post attaches to the base at an offcentered location on the base. Be sure to attach the supporting post in the direction indicated below and attach the stand to the TV with the wider side of the base facing forward.

Long screws

3Build the work table.

4Insert the stand into the openings on the rear the TV.

•Make sure that the stand is fi rmly inserted Improper installation may result in

Soft cushion

5

2 Insert the screw to secure the stand cover.

Short screws