Option menu (Continued)
Fine sync. (PC input mode only) Input signal
•Some input signals may have to be registered manually to display properly.
•The pairs of input signals (resolutions) in the list below are not distinguishable when received. In such case, you have to set the correct signal manually. After setting once, it will display when the same signal (resolution) is input again.
1280 g 768 | 1360 g 768 |
|
|
Adjusting the PC image automatically
Auto sync.
This function enables the screen to be automatically adjusted to its best possible condition when the analogue terminals of the TV and PC are connected with a commercially available RGB cable, etc.
NOTE
•Auto Sync. is likely to succeed when an input PC image has wide vertical stripes (e.g. pattern with high contrast stripes, or
It may fail when an input PC image is solid (low contrast).
Adjusting the PC image manually
Ordinarily you can easily adjust the picture as necessary to change image position using Auto Sync. In some cases, however, manual adjustment is needed to optimise the image.
Selected item | Description |
|
|
Centres the image by moving it to the left | |
| or right. |
|
|
Centres the image by moving it up or | |
| down. |
|
|
Clock | Adjusts when the image flickers with |
| vertical stripes. |
|
|
Phase | Adjusts when characters have low |
| contrast or when the image flickers. |
|
|
NOTE
•For resetting all “Fine sync.” items to the factory preset values, press a/b to select “Reset”, press ENTER, press a/b to select “Yes”, and then press ENTER.
•Images may not be displayed properly depending on the settings and/or input signals.
DivX (R) VOD
Please see USB Media Player on page 28.
Demo (store mode only)
When “Store mode” is set to “On”, after all the settings are completed, the Feature demo screen is displayed if there is no operation for 30 seconds. If you want to have clear picture demo, you must select “Clear picture processing” in the Demo screen. If you want to have fine motion demo, you must select “Fine motion” in Demo screen.
System data
USB data transfer
This function allows you to update the TV to the latest software using a USB device. You must update the software through the USB terminal.
Software update (OAD)
•This function is for automatically download the data for the version update software over digital broadcasts when the “OAD setup” is set to “On”.
•To download, follow the instructions when the download message appears during a digital broadcast.
OAD scan
•This function is for manually download the data for the version update software over digital broadcasts.
CAUTION
•Do not disconnect the AC cord when the software upgrade is in progress, as this may cause the upgrade to fail. If problem arises ask a qualified service personnel before the software upgrade period expires.
18
