Appendix
Troubleshooting
The problems described below are not always caused by malfunctions. Check the TV again before having the TV serviced.
Problem | Possible solution |
• No power. | • Check if you pressed POWER on the remote control unit. (See page 10) |
| If the indicator on the TV lights up red, press POWER. |
•Is the AC cord disconnected?
•Has the power been turned on? (See page 10)
•Unit cannot be operated.• External influences such as lightning, static electricity, etc., may cause improper operation. In this case, operate the unit after first turning the power off the TV or unplugging the AC cord and
• | Remote control unit does not | • | Is battery inserted with polarity (e, f) aligned? (See page 7) |
| operate. | • | Is battery worn out? (Replace with new battery.) |
|
| • | Are you using it under strong or fluorescent lighting? |
|
| • | Is a fluorescent light shining on the remote control sensor? |
|
|
|
|
• | Picture is cut off. | • | Is the image position correct? (See page 18) |
•Are screen mode adjustments such as picture size made correctly? (See pages 13 and 18)
•Strange colour, light colour, or • Adjust the picture tone. (See page 13)
dark, or colour misalignment. • Is the room too bright? The picture may look dark in a room that is too bright.
•Check the colour system setting. (See pages 11 and 17)
•Check the input signal setting. (See page 18)
•Check the HDMI auto view setting. (See page 15)
•Power is suddenly turned off. • The unit’s internal temperature has increased.
|
|
| Remove any objects blocking the vent or clean. |
|
| • | Check the ECO setting. (See page 14) |
|
| • | Is the sleep timer set? (See page 7) |
|
|
|
|
• | No picture. | • | Is the connection to external equipment correct? (See pages 4 to 6) |
|
| • | Has the input signal setup been performed correctly after connection? (See page 18) |
|
| • | Is the correct input selected? |
|
| • | Is the picture adjustment correct? (See page 13) |
|
| • | Is the antenna connected properly? (See page 4) |
|
| • | Is “On” selected in “Audio only”? (See page 17) |
|
|
|
|
• | No sound. | • | Is the volume too low? (See page 7) |
|
| • | Make sure that headphones are not connected. |
|
|
|
|
• | The TV sometimes makes a | • | This is not a malfunction. This happens when the cabinet slightly expands and contracts |
| cracking sound. |
| according to changes in temperature. This does not affect the TV’s performance. |
Cautions regarding use in high and low temperature environments
•When the unit is used in a low temperature space (e.g. room, office), the picture may leave trails or appear slightly delayed. This is not a malfunction, and the unit will recover when the temperature returns to normal.
•Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight or near a
heater, as this may cause the cabinet to deform and the LCD panel to malfunction. Storage temperature: f20°C to e60°C.
29
