62

PC control of the TV

• When a programme is set, the TV can be controlled
from the PC using RS-232C or IP. The input signal (PC/
video) can be selected, the volume can be adjusted and
various other adjustments and settings can be made,
enabling automatic programmed playing.
• Use an RS-232C serial control cable (cross type),
ETHERNET cable (commercially available) or wireless
LAN for the connections.
NOTE
• This operation system should be used by a person who
is accustomed to using PCs.

Communication conditions for IP

ETHERNET cable (commercially available)
Connect to the TV with the following settings made
for IP on the PC.
IP protocol TCP/IP
Host IP address Set the IP address on the TV
menu
Service None (Do not select Telnet
or SSH)
TCP port# Set a port number on the TV
menu (Control port)
When you set your ID and password on the TV
menu, you need to enter them as soon as you
connect to the TV.
NOTE
• The connection will be cut off when there has been no
communication for 3 minutes.

IP Control setup

1Go to “Setup” > “View setting” > “Network Setup”

> “IP Control/Remote app” > “Control setting” >
“Change”.

2To use IP Control, select “Enable”.

3“Detail setting” > Set your login ID and password.

4Set the port to use with IP Control.

5Confirm the settings, and then press “OK”.

Communication conditions for RS-232C

RS-232C serial control cable (cross type)
(commercially available)
Set the RS-232C communications settings on the
PC to match the TV’s communications conditions.
The TV’s communications settings are as follows:
Baud rate 9,600 bps
Data length 8 bits
Parity bit None
Stop bit 1 bit
Flow control None

Communication procedure

Send the control commands from the PC via the
RS-232C connector.
The TV operates according to the received
command and sends a response message to the
PC.
Do not send multiple commands at the same time.
Wait until the PC receives the OK response before
sending the next command.
Make sure to send “A” with the carriage return and
confirm that “ERR” returns before operating.

Command format

Eight ASCII codes +CR

nop

C1 C2 C3 C4 P1 P2 P3 P4

nCommand four digits: Command. The text of

four characters.

oParameter four digits: Parameter 0_9, blank, ?,

minus

pReturn code (0DH): ?

Parameter

Input the parameter values, aligning left, and fill with
blank(s) for the remainder (be sure that four values
are input for the parameter).
When the input parameter is not within an adjustable
range, “ERR” returns (refer to “Response code
format”).
0055
100
0009
0
When “?” is input for some commands, the present
setting value responds.
????

Response code format

Normal response Problem response
(communication error or
incorrect command)
OK ERR
Return code (0DH) Return code (0DH)
Connecting a PC
LAN